ADF4153ABRUZ vs ADF4118YRUZ

ADF4153ABRUZ과 ADF4118YRUZ에 대한 심층 비교를 통해 두 제품의 사양 및 주요 특징에 대한 유용한 정보를 얻을 수 있습니다. RoHS 준수 여부, REACH 인증 상태, 시리즈, 장착 방식, 패키지 유형 및 기타 관련 특성을 포함한 중요한 요소들을 자세히 다룹니다. 두 제품의 차이점을 나란히 제시함으로써 부품 선택이 간소화되어 특정 용도에 가장 적합한 옵션을 쉽게 선택할 수 있습니다.

Technical review by ETEI Component Engineering Source: manufacturer documentation

Replacement verdict

Compatible functional replacement candidate

The ADF4153ABRUZ and ADF4118YRUZ are both fractional-N PLL frequency synthesizers from Analog Devices in a compatible TSSOP-16 package, sharing the same supply voltage range and 3-wire serial interface, so the ADF4153ABRUZ can serve as a functional replacement candidate for the ADF4118YRUZ. However, the two devices differ in maximum operating frequency and RF input sensitivity, so the replacement must be validated against the target frequency plan and loop filter design before adoption.

Package Type High match
Supply Voltage Range High match
Maximum Operating Frequency Validation required
RF Input Sensitivity Validation required

Parts at a glance

Part A

ADF4153ABRUZ

아날로그 디바이스(주)

Lifecycle
Active
Stock
6452 PCS
Package
TSSOP-16
Series
클럭 타이밍 - 클럭 발생기, PLL, 주파수 합성기
Part B

ADF4118YRUZ

아날로그 디바이스(주)

Lifecycle
Active
Stock
5918 PCS
Package
TSSOP-16
Series
클럭 타이밍 - 클럭 발생기, PLL, 주파수 합성기

Key differences

Rows are prioritized by design impact. Highlighted values require attention during substitution.

Key electrical and mechanical differences between the two devices

Parameter ADF4153ABRUZ ADF4118YRUZ Why it matters
Maximum RF Input Frequency 4 GHz 3 GHz Determines the highest frequency the PLL synthesizer can operate at; the ADF4153 supports higher-frequency applications.
Number of Programmable Modulus Bits (Fractional) 4-bit fractional (fractional-N) Integer-N only Fractional-N capability allows finer frequency resolution and lower phase noise for a given reference, which is a fundamental architectural difference affecting substitutability.
Phase Detector Frequency Up to 32 MHz Up to 55 MHz Higher phase detector frequency enables wider loop bandwidth and faster settling; the ADF4118 supports a higher PFD rate.
Supply Voltage Range 2.7 V to 3.3 V 2.7 V to 3.3 V Both operate over the same supply range, so power supply compatibility is maintained between the two parts.
Package 16-Lead TSSOP 16-Lead TSSOP Identical package and pin count simplify board-level replacement and layout reuse.
Normalized Phase Noise Floor -216 dBc/Hz (typical) -212 dBc/Hz (typical) Lower phase noise floor improves spectral purity of the synthesized signal, which is critical for RF system performance.
Charge Pump Current (Programmable) 0.625 mA to 5 mA 0.625 mA to 5 mA Programmable charge pump current allows loop filter optimization; matching ranges ease design migration.
Operating Temperature Range -40°C to +85°C -40°C to +85°C Identical industrial temperature range ensures both parts suit the same environmental conditions.
Interface Type 3-wire SPI 3-wire SPI Same serial interface protocol allows firmware and microcontroller compatibility across both devices.

Need help validating a replacement?

Send your BOM and application constraints for technical and sourcing review.

Full specification comparison

Use manufacturer datasheets as the final authority.

Specification ADF4153ABRUZ ADF4118YRUZ
Supplier - Rochester Electronics, LLC
Series - ADF4118
Part Status Active Active
PLL Yes Yes
Input CMOS, TTL CMOS, TTL
Output Clock Clock
Number of Circuits 1 1
Ratio - Input: Output 2:1 2:1
Differential - Input: Output Yes/No Yes/No
Frequency - Max 4GHz 3GHz
Divider / Multiplier No/Yes Yes/No
Voltage - Supply 2.7V ~ 3.3V 2.7V ~ 5.5V
Operating Temperature -40°C ~ 85°C -40°C ~ 125°C
Mounting Type Surface Mount Surface Mount
Type Fractional N Synthesizer (RF) -

Frequently asked questions

What are the key differences between the ADF4153ABRUZ and ADF4118YRUZ?

The ADF4153ABRUZ is a fractional-N PLL frequency synthesizer, while the ADF4118YRUZ is an integer-N PLL frequency synthesizer. The ADF4153ABRUZ supports fractional-N operation with a programmable modulus, whereas the ADF4118YRUZ uses integer-N division only. Both are housed in 16-lead TSSOP packages and operate from a 3 V supply, but their synthesizer architectures and maximum RF input frequencies differ.

What is the maximum RF input frequency for each device?

The ADF4153ABRUZ has a maximum RF input frequency of 4 GHz. The ADF4118YRUZ has a maximum RF input frequency of 3 GHz. These values are specified in the respective Analog Devices datasheets.

Do the ADF4153ABRUZ and ADF4118YRUZ share the same package and pinout?

Both devices are offered in a 16-lead TSSOP package. However, the pin functions and internal architecture differ because one is fractional-N and the other is integer-N. Designers must consult the respective datasheets before considering any board-level substitution, as the pin assignments are not identical.

What is the operating supply voltage range for these PLL synthesizers?

Both the ADF4153ABRUZ and ADF4118YRUZ operate from a supply voltage range of 2.7 V to 3.3 V, with a nominal 3 V supply. This is specified in the Analog Devices datasheets for both devices.

Can the ADF4153ABRUZ and ADF4118YRUZ be used in the same application interchangeably?

No, they are not directly interchangeable. The ADF4153ABRUZ is a fractional-N synthesizer, while the ADF4118YRUZ is an integer-N synthesizer. Their register maps, programming interfaces, and phase noise performance characteristics differ. A direct replacement would require redesign of the loop filter, register programming, and validation of the RF performance against the target specification.

What are the typical applications for each device?

The ADF4153ABRUZ, as a fractional-N synthesizer, is typically used in applications requiring fine frequency resolution and low phase noise, such as wireless infrastructure, microwave point-to-point links, and instrumentation. The ADF4118YRUZ, as an integer-N synthesizer, is commonly used in cost-sensitive RF applications such as wireless handsets, CATV equipment, and general-purpose frequency synthesis where integer-N division is sufficient.

What is the phase noise performance difference between the two devices?

The ADF4153ABRUZ and ADF4118YRUZ have different phase noise specifications due to their different architectures. The fractional-N architecture of the ADF4153ABRUZ allows for lower phase noise at a given frequency offset when configured with an appropriate loop filter, while the integer-N ADF4118YRUZ has a normalized phase noise floor specified in its datasheet. Designers should refer to the respective Analog Devices datasheets for the exact phase noise figures under specific operating conditions.