사양
| 속성 | 가치 |
| Package | Tape & Reel (TR) |
| ProductStatus | Active |
| MemoryType | Non-Volatile |
| MemoryFormat | FLASH |
| Technology | FLASH - NOR |
| MemorySize | 32Mb (4M x 8) |
| MemoryInterface | SPI - Quad I/O |
| ClockFrequency | 120 MHz |
| WriteCycleTime-WordPage | 2.4ms |
| Voltage-Supply | 1.65V ~ 2V |
| OperatingTemperature | -40°C ~ 85°C (TA) |
| MountingType | Surface Mount |
| Package/Case | 8-XDFN Exposed Pad |
개요
Description
GD25LQ32DQIGR is a 32‑Mbit serial flash memory from GigaDevice (GD25LQ family). It provides a Quad I/O (QIO) serial interface but also supports standard SPI and dual I/O modes, for flexible signaling.
Key features:
- 4 MB of flash storage (32 Mbit)
- Voltage: 2.7–3.6 V
- Fast read up to ~104 MHz SPI; Quad I/O read modes available
- Page program (256 bytes) and block erases (4 KB, 32 KB, 64 KB)
- Write enable, status/protection registers, deep power-down
- 8‑pin package; RoHS-compliant; industrial temperature grade (suffix IG R)
Typical use:
- Firmware/boot code storage for microcontrollers and embedded systems
Note:
- For exact electrical/timing specs and command set, refer to the GD25LQ32DQIGR datasheet from GigaDevice.
Key features:
- 4 MB of flash storage (32 Mbit)
- Voltage: 2.7–3.6 V
- Fast read up to ~104 MHz SPI; Quad I/O read modes available
- Page program (256 bytes) and block erases (4 KB, 32 KB, 64 KB)
- Write enable, status/protection registers, deep power-down
- 8‑pin package; RoHS-compliant; industrial temperature grade (suffix IG R)
Typical use:
- Firmware/boot code storage for microcontrollers and embedded systems
Note:
- For exact electrical/timing specs and command set, refer to the GD25LQ32DQIGR datasheet from GigaDevice.
Equivalent
Common equivalents (32M-bit SPI NOR flash, 3.3V, similar footprint):
- Winbond W25Q32JV / W25Q32FV
- Macronix MX25L3206E
- ISSI IS25LP032D / IS25LP032E
- Spansion/Cypress S25FL032P
- Micron N25Q032
Note: verify exact packaging, timing, and JEDEC/TR behavior in datasheets before substitution.
- Winbond W25Q32JV / W25Q32FV
- Macronix MX25L3206E
- ISSI IS25LP032D / IS25LP032E
- Spansion/Cypress S25FL032P
- Micron N25Q032
Note: verify exact packaging, timing, and JEDEC/TR behavior in datasheets before substitution.
Features
Here are the key features of GD25LQ32DQIGR (32Mbit serial flash):
- 32 Mbit (4 MB) flash memory
- SPI-compatible with Dual/Quad I/O read (QIO/DIO modes)
- Fast read up to 104 MHz (Quad/SPI modes supported)
- Page size 256 bytes; Page Program operation
- Sector/Block architecture: 4 KB sectors; 32 KB and 64 KB blocks; chip erase
- 2.7–3.6 V operating supply (typical 3.0 V)
- Endurance ~100,000 P/E cycles; data retention ~20 years
- Low-power modes: Deep power-down and standby
- Security features via status register (write protection, read/write protection)
- JEDEC ID, Read ID support for device identification
- Temperature range: industrial grade options (typ. -40°C to 85°C)
- 8-pin package (RoHS-compliant) for common board use
Note: exact temp range and packaging variant may depend on the specific grade (industrial/commercial) and revision.
- 32 Mbit (4 MB) flash memory
- SPI-compatible with Dual/Quad I/O read (QIO/DIO modes)
- Fast read up to 104 MHz (Quad/SPI modes supported)
- Page size 256 bytes; Page Program operation
- Sector/Block architecture: 4 KB sectors; 32 KB and 64 KB blocks; chip erase
- 2.7–3.6 V operating supply (typical 3.0 V)
- Endurance ~100,000 P/E cycles; data retention ~20 years
- Low-power modes: Deep power-down and standby
- Security features via status register (write protection, read/write protection)
- JEDEC ID, Read ID support for device identification
- Temperature range: industrial grade options (typ. -40°C to 85°C)
- 8-pin package (RoHS-compliant) for common board use
Note: exact temp range and packaging variant may depend on the specific grade (industrial/commercial) and revision.
Pinout
- Pin count: 8 pins (SOP-8).
- Function: GD25LQ32DQIGR is a 32 Mbit serial NOR flash memory with SPI interface supporting dual/quad I/O (DQ) reads. Pinout typically: CS, CLK, DI (MOSI), DO (MISO), WP#, HOLD#, VCC, VSS. Used to store firmware/data.
- Function: GD25LQ32DQIGR is a 32 Mbit serial NOR flash memory with SPI interface supporting dual/quad I/O (DQ) reads. Pinout typically: CS, CLK, DI (MOSI), DO (MISO), WP#, HOLD#, VCC, VSS. Used to store firmware/data.
Manufacturer
- Manufacturer: GigaDevice Semiconductor Inc. (GigaDevice)
- What kind of company: A Chinese fabless semiconductor company that designs and markets memory products, especially serial NOR/NAND flash and related embedded memory solutions (and related MCUs).
- What kind of company: A Chinese fabless semiconductor company that designs and markets memory products, especially serial NOR/NAND flash and related embedded memory solutions (and related MCUs).
Application
GD25LQ32DQIGR is a 32-Mbit quad-SPI serial NOR flash. Typical applications include:
- Boot and firmware storage for MCUs/SoCs
- OTA firmware updates in IoT, consumer electronics, and wearables
- Non-volatile data logging and parameter storage in automotive, industrial, and medical devices
- Code storage for networking equipment (routers, gateways, modems)
- FPGA/SoC configuration bitstreams and peripheral data
- Embedded graphics/UI firmware in set-top boxes, displays, and multimedia devices
These use cases exploit its non-volatile storage, fast Quad SPI interfaces, and compact packaging.
- Boot and firmware storage for MCUs/SoCs
- OTA firmware updates in IoT, consumer electronics, and wearables
- Non-volatile data logging and parameter storage in automotive, industrial, and medical devices
- Code storage for networking equipment (routers, gateways, modems)
- FPGA/SoC configuration bitstreams and peripheral data
- Embedded graphics/UI firmware in set-top boxes, displays, and multimedia devices
These use cases exploit its non-volatile storage, fast Quad SPI interfaces, and compact packaging.
Package
It uses an 8-pin SOP (SOIC) package; the “GR” suffix denotes a RoHS-compliant lead-free variant.
